2gig Technologies Go Control - Walk Test Mode (Continued); Radio Status Mode; Cell Radio Test; Telephone Test

Final Installation Setup
©2013 2GIG Technologies Inc. All Rights Reserved.
59
6 Presseachtestitemdisplayed,observethe
ControlPanelitembeingtested,andanswer
theyes/noquestionforthetest.
7 Whenallsensorsanddeviceshavebeen
tested,pressOk.TheControlPaneldisplaysa
summaryofthetestresults.Toreturntothe
InstallerToolbox,pressOk.
RADIO STATUS MODE
TheCellRadioModulemustbeinstalledtousethis
function.
TheCellRadioStatusscreendisplaysdataforthe
Cellradio(ifinstalled).Thescreendisplayssignal
strength,serialnumber,registrationstatus,and
otherinformationaboutthecellradiomodule
status.Theinformationmaybehelpfulforradio
installationtroubleshooting.
Cell Radio Test
Tochecktheradiostatus,dothefollowing:
1 FromtheInstallerToolboxscreen,pressthe
RadioStatusbutton.
2 PresstheCellPhoneTestbutton.
3 EntertheMasterUserCode.
4 TheCellPhoneTestScreenappears.Eachtest
itemisdisplayed,followedwithitscurrent
condition.Scrollthroughtheinfoscreenwith
the↓and↑arrows.
•Textisdis
pla
yedinredifthetestedsignal
strengthiszeroortoolow,orthecellradio
moduleisnotregistered.
•Textisdis
pla
yedinorangeiftheconnectionis
idleandthecellradiomoduleisregistered.
•Textisdispla
yedingreenifthesignalstrength
isgoodandthecellradiomoduleisregistered.
5 Whenthetestiscomplete,pressOktoreturn
totheToolbox.
Telephone Test
Thetelephonetestcheckstheland‐lineconnection
totheCentralStationthroughtheControlPanel’s
built‐indigitalcommunicator.Thetestisaccessed
throughtheUserToolboxscreen#3.
1 Ontoolboxscreen#3,presstheTelephone
Testbutton.