2gig Technologies Go Control - Final Installation Setup (Continued); Installer Testing; Sounder Disable;Enable; Zone Reporting Test

Final Installation Setup
©2013 2GIG Technologies Inc. All Rights Reserved.
57
10 TosetthecalendarandtheclockpressSet
DateandSetTime.
OntheSetDatescreen,usethe↓and↑
arrowstosetthemonth,day,andyear.Onthe
SetTimescreen,usethe↓and↑arrowsto
setthehours,minutes,andAM/PM.When
done,pressOk.Aconfirmationscreen
appears.Verifythetimeanddate,thenpress
Okagain.
11 Ifthecellradiomoduleisinstalledand
registered,the dateandtime isset
automatically.
•Tore
turntotheSecu
rityScreen,pressBack
OR
•Tore
turntotheHomeScr
een,pressthe 
button.
INSTALLER TESTING
Testing the System
AftertheinstallationiscompleteandtheControl
Panelprogrammingiscomplete,thesystemmust
betestedtoensureproperoperation.
SystemtestingisperformedthroughtheInstaller
Toolboxscreen.
1 PressthelowerrightcorneroftheHome
screen.
2 ToaccesstheInstallerToolbox,enterthe
InstallerCode(default=1561).
Sounder Disable/Enable
Becausete s tingcausestheControlPanel’ sinternal
andexternalalarmsoundertoactivate,anoption
tolowerthesounderisavailable.
1 FromtheInstallerToolboxScreen,press
DisableSounder.
2 Aconfirmationscreenappears.PressOk.Four
beepswill soundfromtheinternalsounder,
andashortsirenwillsoundfromtheexternal
sounder.Theexternalsirenwillbedisabled
andtheinternalsounderwillbeloweredfor
30minutes.
3 Asecondconfirmationscreenappearsto
verifythatthetes tsoundsoccurred.PressOk.
4 Whilethesounderisdisabled,theSounder
DisableIconappearsonthestatusbar.
5 TheSounderDisableautomaticallytimesout
after30minutes,andthesounder
automaticallybecomesactiveagain.
Tore‐enablethesoundermanually
,fo
llowthese
steps:
1 FromtheInstallerToolboxScreen,press
EnableSounder.
2 Aconfirmationscreenappears.PressOk.
Zone Reporting Test
ToverifythattheCentralStationcorrectlyreceives
reportsfromeachzone(sensortype),dothe
followingtests:
1 InformtheCentralStationthattestsignalswill
besent.
2 Triggera24‐hourfiresensor(ifinstalled)or
presstheFireemergencybutton(ifenabled),
waitabout45secondsforthereportto
complete,thendisarmtheConsole.