2gig Technologies Go Control - Final Installation Setup; Exiting Programming (System Configuration); Customizing the Installation; User Management

56 ©2013 2GIG Technologies Inc. All Rights Reserved.
FINAL INSTALLATION SETUP
EXITING PROGRAMMING
(SYSTEM CONFIGURATION)
AfterprogrammingtheControlPanel,allthe
changesneedtobesavedinmemory.Aftersaving,
theprogrammedsettingswillremaininmemory,
evenafteratotalpowerloss.
1 Aftersettingalltherequiredprogramming
valuesforthesensorsandtheControlPanel,
pressEnd.
2 ReviewtheSummaryofSystemConfiguration
Screen.Usethe↓and↑arrowstoscroll
throughthelisting.Verifythateachoptionis
setcorrectly.
3 Tosavetheprogrammingchanges,besurethe
SaveChangesoptionischecked.Toexit
withoutsavingprogrammingchangesun‐
checktheSaveChangesoption(for
verification,anadditionalconfirmationscreen
appears).PressExit.
4 TheControlPaneltakesafewsecondsto
restartanddisplaytheHomeScreen.
Customizing the Installation
AfterprogrammingtheControlPanel,gotothe
UserToolboxandcustomizethesystemtosuitthe
installation.ToaccesstheUserToolbox,dothe
following:
1 FromtheHomeScreen,pressSecurity.
2 FromtheSecurityScreen,press,Menu.
3 FromtheMenuScreen,PressToolbox.
4 EntertheMasterUserCode(default=1111).
5 PressUserManagement.
6 Toadd,change,ordeleteaUserCode,pressa
Userbutton.Thesystemaskstoconfirmthe
codeentered.BesuretosetaDuressCodeas
User#8.
NOTE: Usercodes0000,0001,andthe
InstallerCodearenotpermitted.
7 SetupeachUserCodewiththeUserAccess
OptionScreen.EachUserCodecanbesetto
becurrentlyvalidornot,ortohave
conditionalvalidity.Ref ertotheUserGuidefor
detailsonsettingUserCodeAccessSchedules.
Whendone,pressBack.
8 PressBrightness/Volume.Setthelevelforthe
displaybrightness.Setthechime&voice
volume.Whendone,pressOk.
9 Toviewthe2ndToolboxScreen,press→.To
setthedisplaylightingtimeout,pressBack
LightTimeout.Choosethelengthoftimethat
thedisplaywillremainlitafteritisidle.When
done,pressOk.