AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 352 01/2011 Installation and activation
6.3.2 Handling cards
This operation may be necessary, especially for preconfiguring the switches of a card or
installing a daughter card on this same card.
Attention :All the cards cannot be hot-unplugged. Refer to the list below.
The following cards can be removed or inserted when powered on in a cabinet:
• UCV-D, RUCV-D and IUCV-D (AXD cabinet)
• LA16X, LA16X-8, LN16X, LN16X-8, LH16X, LH16X-8, LD4N, LD4X (AXD, AXL, AXS,
AXS12 and AXS6 cabinets).
All the other cards must be powered off before being removed from or inserted in an AXD,
AXL, AXS, AXS12 or AXS6 cabinet. For this, it is necessary to power off the iPBX (see
Section 6.4).
Nota : For the IPS card, it is advisable to stop the IPS card before powering off the
iPBX. Note that there is a minor risk of information loss if the IPS card is powered
off before it is stopped.
For cards that can be removed while the system is running
• Disable the card. See Aastra Management Portal operating manual
• Remove the card from the cabinet.
• Place the card on an antistatic envelope.
• Carry out the necessary operation on the card (reconfiguring the switches or inserting
a daughter card).
• Re-insert the card in the cabinet.
• Activate the card. See Aastra Management Portal operating manual
For cards that cannot be removed while the system is running
• Stop the iPBX (refer to the Section Stopping the system (AXD, AXL, AXS, AXS12 and
AXS6)).
• Remove the card from the cabinet.
• Place the card on an antistatic envelope.
• Carry out the necessary operation on the card (reconfiguring the switches or inserting
a daughter card).
• Re-insert the card in the cabinet.
• Restart the iPBX.
To Next Page
Loading...
Need help?
General
