Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 393
section).
6.12.1.5 Restoring data from the USB key
6.12.1.5.1Pre-requisites
The cabinet must be restarted correctly.
The software release is valid.
The USB key containing the backup is connected.
Important : Before any restore operation, check the software release of the new card
which must be at least equal to the previous one. If this is not the case,
upgrade the software as described in Section 6.7 or 6.9.
6.12.1.5.2Procedure
When it accesses the menu SYSTEM/Software maintenance/Compact flash migration, the iPBX
detects that all the data to be restored is on the connected USB.
The following button is then displayed:
Restore the content of the USB key
This unique button is used to start data import in the iPBX.
Like for the previous case, a progress pop-up window is displayed during the restore operation. The
restore operation takes place like the backup operation, in 6 phases. Here again, the operations may
last several minutes. This restore operation takes place in the inactive space. After the restore
operation, an automatic reset takes place to restart on the inactive release.
At the end of the restore operation and before reset is activated on the iPBX, if backup has been
performed correctly, the following message is displayed:
Operation completed correctly
The restored data has been deleted from the key, and the key removed.
During the iPBX restart phase, the following message is displayed:
Restart in progress, please wait xx seconds.
In case of error, a dialogue box indicates that the restore operation has not been performed correctly.
In this case, all the data remains on the USB key. The key is not removed automatically; it will be
removed upon exiting the menu.
The restore operation lasts for about 6 minutes depending on the content to be restored and the
original and target software releases.
Then validate the software release.
To Next Page
Loading...
Need help?
General
