Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
INSTALLING A5000 SERVER (Non-redundant)01/2011 Page 459
10 INSTALLING A5000 SERVER (NON-REDUNDANT)
This chapter describes how to install the non-redundant A5000 Server application. For the
redundant Aastra 5000 server, refer to AMT/PTD/PBX/0083.
10.1 Important pre-requisite
As of R5.2, the Linux operating system, Red Hat 5.4 minimum, must first be installed on
the PC. Refer to the document Red Hat OS installation Manual.
The PC network must have been declared and configured (if necessary, contact the
network administrator).
The PC must be connected to the network to which it is dedicated (network cable
connected).
For the system to work correctly with Red Hat 5 .4:
• Deactivate SELinux (See the procedure described in the appendix to this document).
• Deactivate the firewall in order to authorise http and https requests (see the procedure
described in the appendix to this document).
• Connect the USB dongle for the A5000 Server application.
10.2 Installing the A5000 Server application
• Switch on the PC on which the application is to be installed.
• Place the CD-ROM in the CD-ROM drive when Linux is started.
Attention :When a CD-ROM is installed with the PC, installation script execution rights are
not assigned by default; to configure these execution rights, see the Section
"Configuring storage device execution rights" in the Red Hat OS Installation
Manual - AMT/PTD/NMA/0040.
• Open a "My computer" window.
• Double-click the CD icon so it can be detected by the system.
Start the installation by double-clicking the the file install_a5000_server.sh, located in
the CDROM root.
• ClickRun
The script is then automatically executed without the user’s intervention.
To Next Page
Loading...
Need help?
General
