Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 379
6.8.3 Restarting and validating the new version
Rappel : After restarting in R5.2, it is necessary to refresh the browser screen to access
AMP. It is advisable to close and restart it. Moreover, it could be necessary to
erase the cookies and the temporary files of the navigator to obtain a correct
display in the Web browser.
After the software is upgraded, the installed version is not automatically validated during
switchover. You must validate the new version manually after noticing that it is running
satisfactorily.
You can validate it through the menu "SYSTEM > Restart request".
IMPORTANT NOTES:
As long as the new version is not validated:
•it remains "in test",
• a red frame is displayed in the menu area indicating that the active version is not valid.
• It is possible to restore the previous version (see SYSTEM> Restart request) but the
data modified while the software had not been validated will be lost.
Attention :The restore operation will not be possible on the recovered version.
• It is not possible to back up data until the software is validated.
It is advisable to validate the new version as quickly as possible (once
you observe a normal operation).
Procedure
Validation and possible cancel requests are proposed in the menu "SYSTEM/Restart
request" as indicated below.
• To validate the release "in test", click “Validate the version”. The system restarts
To Next Page
Loading...
Need help?
General
