AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 362 01/2011 Installation and activation
6.3.7 Adding an expansion cabinet
The iPBX can be fitted with one or more expansion cards to increase the system capacity.
Avertissement : The configuration data needs to be changed if the system is expanded.
Before adding new components, first back up the data.
6.3.7.1 Adding an expansion cabinet (AXD)
Procedure
• Back up the customer configuration.
• Power off the iPBX.
• Install the expansion cabinet cards.
• Install the expansion cabinet and connect it to earth (see Sections 3 and 6.2.5).
• Connect the expansion cabinet to the main cabinet using the connection cable(s),
according to the simplex or duplex configuration of the cabinets and colour codes (see
Sections 4.5.4.1).
• Install the cable on the front panel of the expansion cabinet cards.
• Install the battery cabinet if available.
• Connect the two battery leads.
• Make sure the polarity is correct.
• Connect the battery to the "48V BATT." connector located at the back of the AXD
cabinet.
• Connect one end of the mains cable to the power supply module(s) of the expansion
cabinet and the other end to a grounded mains power point.
• Power on the iPBX (expansion cabinets first then the main cabinet).
• Check that the yellow and green indicators on the front panel of the cabinet sub-
assemblies are lit, and that no red indicator is on (refer to Sections 4.3 to 4.14 to check
that the operating conditions shown by the indicators are correct).
• From the AMP, check that the software has detected the cabinet expansion.
• Configure the new expansion cabinet equipment
(see AMP operating manual).
• Save the configuration.
To Next Page
Loading...
Need help?
General
