Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 353
6.3.3 Adding a CLX card (AXD, AXL, AXS, AXS12 and AXS6)
The iPBX can be fitted with one or more expansion cards to increase the system capacity.
In an iPBX, it is possible to install all types of expansion cards according to the existing
configuration and hardware configuration rules.
Attention : Except for the IPS card, a CLX card is only authorised in the main cabinet of an iPBX.
CONTRAINTE
• Refer to section 3.5 to check the constraints imposed by the hardware configuration
rules.
• Check any particular installation and wiring details for the card to be added
(see Sections 4.6 to 4.14).
• The configuration data needs to be changed if the system is expanded. Before adding
new components, the data must be saved on hard disk or floppy.
• Immediately after installing and programming any new components, you should make
a second backup, to save the system's new configuration.
Procedure
• Back up the customer configuration.
• Check the compatibility between the card to be installed and its slot in the main or
expansion cabinet (see section3.5).
• Check that the cards fitted with configuration microswitches are configured correctly
(see sections 4.13 to 4.14).
• Check that the cards which can be fitted with daughter cards (according to the
customer's installation) are equipped correctly (see Sections 4.6 to 4.14).
• If required, install the daughter cards on the cards requiring them.
• Stop the iPBX.
• (1) An LD4NX card can be hot-plugged in an AXD, AXL, AXS, AXS12 or AXS6 iPBX in
normal operation.
• (2) It is advisable to stop the IPS card before powering off the iPBX.
• Remove the blanking plate:
- Turn the plate 1/4 turn locks by 1/4 turn (see section 4.1).
- Remove the blanking plate of the slot where the card is to be installed.
• Insert the card in the required slot and slide the card along the card guides until it clicks
into place.
• Lock the card in place using the 1/4 turn locks (see Section 4.1).
• Install the cables on the card’s front panel.
• Restart the iPBX.
To Next Page
Loading...
Need help?
General
