Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 369
6.4 Stopping the system (AXD, AXL, AXS, AXS12 and AXS6)
The same procedure for all these cabinet types.
You must respect the order of this procedure:
• On the CPU card, press briefly the "SHTD" (Shutdown) button. Wait for the green
"SHTD" indicator light to be steady on, and for the other ones to go off.
• Power off the power modules (I/O push button on O).
6.5 Stopping the system (AXD, AXL, AXS, AXS12 and AXS6)
Note : Only restart modes from the CPU card front panel are described in this paragraph. Restart
requests from Aastra Management Portal are not described here. See Aastra Management
Portal operating manual .
The same procedure for all these cabinet types.
From the buttons on the CPU card front panel, you have to distinguish between two types
of restart operations:
• Restart with OS reboot (shutting down and restarting the iPBX)
• Forced restart (not recommended in normal operation).
Restart with OS reboot (shutting down and restarting the iPBX)
• Pressing and holding down the "SHTD" button (5 seconds), triggers an "OS reboot"
(shutdown + iPBX restart).
• The system restarts.
• Wait some moments before accessing AMP again.
Forced restart (not recommended in normal operation)
•Press "RST". This button should only be used as last resort if pressing the "SHTD"
button does not work.
• The system restarts.
• Wait some moments before accessing AMP again.
After the restart operation, check the status of the indicators on the front panel of the
cabinet (see Section Description des sous-ensembles).
To Next Page
Loading...
Need help?
General
