AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 388 01/2011 Installation and activation
6.11.3 ACCESSING THE USER INTERFACE (AMP) VIA AN ISDN ROUTER
In this release (R5.1A), the router must mask the PC address (NAT); the iPBX only sees
an IP address on the PPP link (all the others are routed over the LAN port, the connection
would not be set up).
6.11.3.1 CONNECTIONS
• ISDN cable: router RJ45, LD4X or LT2 or operator RJ45.
• Ethernet cable: RJ45 -RJ45
PBX CONFIGURATION
• S0 or S2 parameter
• S0: Call without ID at Yes (menu 414)
• S2: Call without ID at yes
• CRC4 management at yes
AMP BROWSER ACCESS
• Open a web browser installed on the operating console (Internet Explorer, for
instance).
• Enter the address reserved for this access mode: https://192.168.1.101 (secure
access mode).
To Next Page
Loading...
Need help?
General
