AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 360 01/2011 Installation and activation
6.3.6.1.2 Duplex AXD configuration
CONTRAINTE
The same number and type of EIP cards (32 or 8 channels) on each UCV-D card with the same slot.
This configuration requires changing the system status, which results in the loss of on-going calls
(see below).
The configuration data needs to be changed if the system is expanded. Before adding new
components, first back up the data.
Immediately after installing and programming any new components, you should make a second
backup, to save the system's new configuration.
Procedure
• Back up the configuration.
• Remove the passive UCV-D card.
• Install the EIP cards on the appropriate connectors.
• Re-insert the (passive) UCV-D card fitted with EIP cards.
See Aastra Management Portal operating manual for the different phases.
• Change the passive CPU card to “active card” mode.
• Declare the network parameters of the EIP cards.
Nota : The internal IP address of the IP cards must be declared on the same sub-
network as that of the CPU card.
• Activate the EIP cards.
• Check the status of the EIP indicators on the front panel (see Sections 4.3 to 4.14).
• Connect the EIP cards to the network.
• Remove the passive UCV-D card.
• Install the EIP cards on the appropriate connectors.
• Re-insert the (passive) UCV-D card fitted with EIP cards.
The IP settings of the EIP cards on the second card will be automatically taken into
account later by the software (same settings on both CPU cards).
• Save the configuration.
To Next Page
Loading...
Need help?
General
