Installation and Maintenance Manual - Aastra 5000 AMT/PTD/PBX/0058/4/6/EN
Installation and activation 01/2011 Page 391
If a key is detected, the window is displayed in form of a single button, prompting you to
back up the data to be migrated, on the key:
Start the backup on the USB key
Press this button to start backing up data on the USB key. A wait message is displayed
during the backup operation.
The backup operation may take several minutes, depending especially on the number of
voice messages and amount of TMA data available on the 1 GB compact flash card.
When the backup operation has been correctly completed, the following message
appears:
Operation completed correctly
The USB key is automatically removed at the end of the backup operation.
You can then exit the menu and disconnect the key which now contains the migrated
data.
In case of error, a dialogue box indicates that the backup has not been performed
correctly. In this case, the data has not been fully stored on the key. The key is not
removed automatically; it will be removed upon exiting the menu.
6.12.1.2.2Error messages
The following error messages may be displayed when data is being backed up on the
USB key:
•«Transfer error x " means that an error occurred while data was being copied in
phase x.
•«System error, exit and retry " means that no key is connected or that the
maintenance software cannot execute the backup action.
•«Forbidden function: version in test " means that the software release is not valid.
•«Other transfer in progress " means that automatic TMA actions have not been
completed.
•«Cannot delete " means that the USB key cannot be deleted before the backup
operations start.
•«Error of directory creation " means that target directories cannot be created on the
USB key.
•«Not enough free disk space " means that the space available on the key is not
enough to contain all the data backed up.
•«Impossible export " means that the data BACKUP file cannot be created.
To Next Page
Loading...
Need help?
General
