ABB ACQ810 - Page 255

Parameters 255
77.05 Sleep ext sel Defines a source that is used by parameter 77.01 Sleep
mode sel, selections External, Int+ext and Soft ext. See the
descriptions of those selections for the usage of this signal
source.
Not used No source selected. 0
DI1 Digital input DI1 (as indicated by 02.01 DI status, bit 0). 1073742337
DI2 Digital input DI2 (as indicated by 02.01 DI status, bit 1). 1073807873
DI3 Digital input DI3 (as indicated by 02.01 DI status, bit 2). 1073873409
DI4 Digital input DI4 (as indicated by 02.01 DI status, bit 3). 1073938945
DI5 Digital input DI5 (as indicated by 02.01 DI status, bit 4). 1074004481
Const Bit pointer setting (see Terms and abbreviations on page
109).
-
Pointer
77.06 Sleep boost step When the drive is entering sleep mode, the setpoint is
increased by this percentage for the time defined by
parameter 77.07 Sleep boost time.
No auxiliary pumps are started. If active, sleep boost is
aborted when the drive wakes up. See the diagram in
section Sleep function (starting page 59).
0.00 … 32767.00 % Sleep boost step. 100 = 1%
77.07 Sleep boost time Sets the boost time for the sleep boost step defined by
parameter 77.06 Sleep boost step.
0…100 s Sleep boost time. 1 = 1 s
77.08 Wake up mode sel Selects the signal that is compared to the wake up level
77.10 Wake up level, and the condition that must be true for
the drive to wake up.
If the selected condition does not remain true until the wake-
up delay (77.11 Wake up delay) expires, the delay counter is
reset.
Wake > ref If the process actual value (see group 28 Procact sel)
remains below the process setpoint (see group 29 Setpoint
sel) multiplied by the wake-up level for longer than the wake-
up delay (77.11 Wake up delay), the drive wakes up. See the
diagram below.
0
No. Name/Value Description FbEq
Process setpoint × Wake-up level (77.10) / 100
Process actual value
Wake-up delay (77.11)
Time
SLEEPING