Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the CRB 15000 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Used for CRB 15000-5/0.95.
Also order new Cable tie:
3HAC075545-001.
3HAC073206-001Cable harness, joint 5
Used for CRB 15000-10/1.52.
Also order new Cable tie:
3HAC075545-001.
3HAC083669-001Cable harness, joint 5 (CRB 15000-
10/1.52)
Used for CRB 15000-12/1.27.
Also order new Cable tie:
3HAC075545-001.
3HAC083668-001Cable harness, joint 5 (CRB 15000-
12/1.27)
For securing joint unit cable.3HAC075545-001Cable tie
Required tools and equipment
NoteArticle numberEquipment
For joint units on axes 4, 5 and 6.
Attachment screws M3x12 (4 pcs)
are enclosed.
3HAC077789-001Lifting aid
Always use guide pins in pairs.
For joint units on axes 4, 5 and 6.
3HAC077787-001Guide pin, M3x110
Used to handle drive board con-
nectors.
-Tweezers
For protection of drive board
during cabling installation on joint
units of CRB 15000-5/0.95.
3HAC077790-001Protection plate
HellermannTyton 110-77001 or
similar
-Cable tie gun EVO 7i
Content is defined in section
Standard toolkit on page 1087.
-Standard toolkit
Required consumables
NoteArticle numberConsumable
-Cable ties
Axis-5 cover, used for CRB
15000-5/0.95.
Replace if damaged.
3HAC061327-051O-ring
Axis-5 cover, used for CRB
15000-10/1.52 and CRB 15000-
12/1.27.
Replace if damaged.
3HAC061327-051O-ring
Continues on next page
418 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.3.6 Replacing the axis-5 cabling
Continued
To Next Page
Loading...
