Removing the tilt
NoteAction
Guide pin, M3x110: 3HAC077787-
001
Remove two attachment screws and fit two guide
pins to the axis-5 joint unit.
1
Always use guide pins in pairs.
xx2000002128
xx2000002129
xx2000002130
Remove the remaining attachment screws.2
Press the tilt out of position using two of the pre-
vious attachment screws as removal tools.
3
xx2000002131
Remove the tilt from the tubular.
Assist the cabling to be removed while lifting away
the complete tilt.
Place the tilt on a workbench.
4
Continues on next page
604 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.4.4 Replacing the wrist housing
Continued
To Next Page
Loading...
