ABB CRB 15000 - Page 942

Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the CRB 15000 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Used for CRB 15000-5/0.95.
New attachment screws and
cable tie 3HAC075545-001 are
included in the delivery.
3HAC079143-001Joint unit
New attachment screws and
cable tie 3HAC075545-001 are
included in the delivery.
3HAC087546-001Joint unit
Required tools and equipment
NoteArticle numberEquipment
For joint units on axes 4, 5 and 6.
Attachment screws M3x12 (4 pcs)
are enclosed.
3HAC077789-001Lifting aid
Always use guide pins in pairs.
For joint units on axes 4, 5 and 6.
3HAC077787-001Guide pin, M3x110
For protection of drive board
during cabling installation on joint
units of CRB 15000-5/0.95.
3HAC077790-001Protection plate
For protection of drive board
during cabling installation on joint
units of CRB 15000-10/1.52 and
CRB 15000-12/1.27.
3HAC087789-001Protection plate
HellermannTyton 110-77001 or
similar
-Cable tie gun EVO 7i
Used to handle drive board con-
nectors.
-Tweezers
Content is defined in section
Standard toolkit on page 1087.
-Standard toolkit
Required consumables
NoteArticle numberConsumable
Isopropanol-Cleaning agent
Loctite 574-Flange sealant
-Cable ties
Tubular cover, used for CRB
15000-5/0.95.
Replace if damaged.
3HAC061327-043O-ring
Continues on next page
942 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.6.6 Replacing the axis-4 joint unit
Continued