The following table shows the connections to the DeviceNet connector:
FunctionWire colorSignal nameI/O pin
DeviceNet network negative power ( 0 V)blackV-1
DeviceNet communication network terminal
(low)
blueCANL2
Network cable shieldbareShield3
DeviceNet communication network terminal
(high)
whiteCANH4
DeviceNet network positive power ( 24 V DC)redV+5
This connector is internally connected with the optional DeviceNet board
(DSQC1006). The X17 is the predefined connection to the DeviceNet board in main
computer for the customer.
Tip
The DeviceNet network needs to be powered by a separate 24 V power supply,
or the DeviceNet function will not work.
See Application manual - DeviceNet Master/Slave, 3HAC066562-001, section
"Hardware overview" for more information on how to connect 24 V to the
DeviceNet network.
For connection details, see Circuit diagram - OmniCore C30, Circuit
diagram - OmniCore C30 for IRB 14050, Circuit diagram - OmniCore C30 for CRB
15000, 3HAC059896-009, 3HAC063898-009, 3HAC072448-009.
X45 - IP20 power outlet connector (option)
xx1700001064
IP20 Power outlet connectorA
Continues on next page
124 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.8 Descriptions for connectors
Continued
To Next Page
Loading...
