Note/IllustrationAction
Screws: Torx, countersunk screw M4x10 (4
pcs)
xx1800001179
Insert the harness double SMB into the
front panel from inside the cabinet and
secure the screws.
4
Refitting the axis computer to the frame
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Location of wrist strap button:
xx1800000683
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
2
Reconnect and secure the screw:
• K6.X4, K6.X5 - SMB.
3
Continues on next page
Product manual - OmniCore C30 139
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.1 Installing the harness for double SMB
Continued
To Next Page
Loading...
