ABB OmniCore C30 - Page 376

Note/IllustrationAction
xx1800000549
Remove the attachment screws and lift
the power supply out.
2
Disconnect:
• T5.X2 - X45
3
Removing the power supply baseline
Note/IllustrationAction
Disconnect:
• T2.X1 - A1.X6
• T2.X2 - K2.X1
1
Continues on next page
376 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.12 Replacing the drive unit
Continued