Refitting the power supply optional
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 31.
1
Location of wrist strap button:
xx1800000683
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 47.
2
Fit the power supply.3
Reconnect:
• T5.X2 - X45.
4
Screws: Torx pan head screw M4x8 (4 pcs)
xx1800000550
Secure the screws.5
Reconnect:
• A1.X7 - T5.X1
6
Continues on next page
422 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.2.1 Replacing the motor connector
Continued
To Next Page
Loading...
