ABB OmniCore V250XT Type B - Page 132

Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT Type B via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
DSQC 6093HAC14178-1DSQC 609 power supply
DSQC 6343HAC13398-2DSQC 634 power supply
DSQC 609 and DSQC 6343HAC082083-001Harness PSU 24V
DSQC 609 and DSQC 6343HAC082508-001Harness PSU
3HAB7983-1End clamp
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 426.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT, rev 04 or later
Installing the optional power supply
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Opening the door on page 184.Open the door.2
Continues on next page
132 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.5 Installing the power supply optional device
Continued