Note/IllustrationAction
xx1900002336
Slide the grommets into the frame halves.
Note
It must be ensured that the flat side of
the grommets in the lower row are point-
ing to the open side of the frame half (flat
sides pointing upwards).
Note
The fl at side of the grommets in the up-
per row have to point downwards so that
all flat sides rest on each other. When
using single row frames the fl at side has
to point towards the cover strip.
2
xx1900002335
Refit the cover strip onto the frame.3
Screws: Hex socket head cap screw M5x50
12.9 Lafre 2C2B/FC6.9 (3 pcs)
Secure the frame and cover strip with the
screws.
4
Tightening torque: 2 Nm - 3 Nm.
xx1900002334
Continues on next page
Product manual - OmniCore V250XT Type B 143
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.7 Installing the cable grommet assembly
Continued
To Next Page
Loading...
