Note/IllustrationAction
xx1900002333
Route the cables through the cut-out.5
Screws: Torx pan head screw M4x8 (4 pcs)Refit the cable entry frame to the enclos-
ure wall and secure with the screws.
6
Tightening torque: 1.5 Nm.
xx1900002332
Refitting the cable grommet assembly
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Continues on next page
144 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.7 Installing the cable grommet assembly
Continued
To Next Page
Loading...
