Installing the mains connections cable
The following procedures detail how to connect incoming mains to the controller
through a cable gland.
Note/illustrationAction
xx2100002286
Remove the dust protection lid from the
cable gland (A).
1
A Cable gland
B Incoming mains switch
C Cable pipe
Remove protection from the incoming
mains switch (B).
2
Continues on next page
Product manual - OmniCore V250XT Type B 151
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
3 Installation and commissioning
3.7.9 Installing the mains connections cable
Continued
To Next Page
Loading...
