Closing the door
Closing the door
Info/illustrationAction
If door stop has been used during main-
tenance, place the door stop in its origin-
al position.
1
Push the door back.2
Turn the handle clockwise and push it
back into the lock.
3
Turn the key back and take it out.4
Removing the controller covers
Preparations
Info/illustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2200001817
Continues on next page
Product manual - OmniCore V250XT Type B 185
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.1 Opening the robot controller
Continued
To Next Page
Loading...
