ABB OmniCore V250XT Type B - Page 193

Note/IllustrationAction
xx2200001064
Place the external fan in the bracket and
secure it with the screws and cable ties.
3
xx2200001063
Position the fan bracket in the controller
and secure the screws.
4
Reconnect any connectors disconnected
at removal.
5
Concluding procedure
Note/IllustrationAction
Refitting the rear cover on page 187.Refit the rear cover of the controller.1
Make sure that the filter cover plate is
correctly positioned.
2
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 173.
3
Product manual - OmniCore V250XT Type B 193
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.2.1.1 Replacing the external fans
Continued