ABB OmniCore V250XT Type B - Page 209

Note/IllustrationAction
xx2300001835
Hook up the Ethernet extension switch
to the bracket and then push the switch
into position.
Note
During the installation, there should be
no gap between the upper surface of the
Ethernet extension switch and the lower
surface of highest bracket on the main
computer.
xx1800000972
3
Reconnect any connectors disconnected
at removal.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 185.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 173.
2
Product manual - OmniCore V250XT Type B 209
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.3 Replacing the Ethernet switch (DSQC1035)
Continued