Note/IllustrationAction
xx2300001836
Hook up the Connected Services gate-
way to the bracket and push carefully into
position.
3
Reconnect any connectors disconnected
at removal.
4
Reconnecting the antenna
Note/IllustrationAction
Note
The operating conditions must be such that
there is a minimum separation distance of
20 cm between the dedicated antenna and
nearby persons.
Place the magnet part of the antenna on
the outside of the cabinet.
1
Note
The Connected Services antenna is installed
by the customer, and the cable routing can
therefore differ.
Follow the cable routing recorded during
the disassembly when you reconnect the
antenna cable.
2
xx2200001973
Insert the antenna cable through the
cable grommet.
3
Apply cable ties and suitable cable pro-
tection to ensure that the cable may not
be damaged by the door.
4
Continues on next page
Product manual - OmniCore V250XT Type B 215
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.4 Replacing the 3G Connected Services gateway
Continued
To Next Page
Loading...
