ABB OmniCore V250XT Type B - Page 218

NoteArticle numberSpare part
DSQC10933HAC086677-001Connected Services 4G EU [3013-
5]
DSQC1093A3HAC086678-001Connected Services 4G US [3013-
6]
3HAC086604-001Magnetic roof antenna 4G
Harness A2.K4.X1 - K7.ETH23HAC085903-001Ethernet harness
Harness Adapter - K7.X13HAC085904-00124V Adapter harness
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 426.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT, rev 04 or later
Removing the Connected Services gateway
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Opening the door on page 184.Open the door.2
Continues on next page
218 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the 4G Connected Services gateway
Continued