ABB OmniCore V250XT Type B - Page 273

Removing the DeviceNet board
Note/IllustrationAction
xx2300000921
Loosen the screws that hold the Devi-
ceNet board unit.
1
Remove the DeviceNet board unit from
the slot in the main computer assembly.
2
Refitting the DeviceNet board
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Opening the door on page 184.Open the door.2
Continues on next page
Product manual - OmniCore V250XT Type B 273
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.15 Replacing the DeviceNet board
Continued