Removing the break resistor bleeder
Note/IllustrationAction
Remove the cable ties.1
Disconnect all connectors from the unit
to be replaced.
2
xx2200001073
Remove the screw holding the break
resistor bleeder bracket.
3
xx2200001074
Remove the screws holding the break
resistor bleeder.
4
Remove the break resistor bleeder and
pull the cables through the opening.
5
Continues on next page
286 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder
Continued
To Next Page
Loading...
