Refitting the break resistor bleeder
Refitting the break resistor bleeder
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2200001817
xx2200001074
Refit the break resistor bleeder and se-
cure the screws.
3
Continues on next page
Product manual - OmniCore V250XT Type B 287
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder
Continued
To Next Page
Loading...
