ABB OmniCore V250XT Type B - Page 288

Note/IllustrationAction
xx2200001074
Secure the screw holding the break res-
istor bleeder bracket.
4
Reconnect any connectors disconnected
at removal.
5
Concluding procedure
Note/IllustrationAction
Refitting the rear cover on page 187.Refit the rear cover of the controller.1
Closing the door on page 185.Close the door.2
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 173.
3
288 Product manual - OmniCore V250XT Type B
3HAC087112-001 Revision: A
© Copyright 2023-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder
Continued