EasyManua.ls Logo

ABB PVS980-58 - Page 93

ABB PVS980-58
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parameters 91
150.16 FBA A Status Word Shows status word sent by fieldbus adapter A to the
master (PLC).
This parameter is read-only.
-/ Data
150.17 FBA A Actual value 1 Shows raw actual value ACT1 sent by fieldbus adapter
A to the master (PLC).
This parameter is read-only.
-/ Real
-2147483648...
2147483647
Fieldbus adapter A actual value 1. 1 = 1
150.18 FBA A Actual value 2 Shows raw actual value ACT2 sent by fieldbus adapter
A to the master (PLC).
This parameter is read-only.
-/ Real
-2147483648...
2147483647
Fieldbus adapter A actual value 2. 1 = 1
150.21 FBA A Timelevel sel Selects communication speed.
In general, lower speeds reduce CPU load. The table
below shows the read/write intervals for cyclic and
acyclic data with each parameter setting.
*Cyclic data consists of fieldbus Control and Status
words, Ref1, Ref2, Act1 and Act2.
**Acyclic data consists of the parameter data mapped to
parameter groups 155 FBA B data in and 156 FBA B
data out.
Fast/ List
Monitoring Low speed. Optimized for PC tool communication and
monitoring usage.
0
Normal Normal speed. 1
Fast Fast speed. 2
150.31 FBA B Enable Enables communication between the inverter and
fieldbus adapter B, and specifies the slot the adapter is
installed into.
Disabled/ List
Disabled Communication between inverter and fieldbus adapter B
disabled.
0
Option slot 1 Communication between inverter and fieldbus adapter B
enabled. The adapter is in slot 1.
1
Option slot 2 Communication between inverter and fieldbus adapter B
enabled. The adapter is in slot 2.
2
Option slot 3 Communication between inverter and fieldbus adapter B
enabled. The adapter is in slot 3.
3
150.32 FBA B comm loss func Selects how the inverter reacts in a fieldbus
communication break. The time delay is defined by
parameter 50.03 Comm loss t out.
No action/
Real
No action Communication break does not cause any actions. 0
Fault Inverter trips on fault PANEL LOSS (FFFF) and the
inverter coasts to stop.
1
Fault always Inverter trips on fault and the inverter coasts to stop
always, when communication lost is noticed.
2
No. Name/Value Description Def/
FbEq16/32
Selection Cyclic* Acyclic**
Monitoring 10 ms 10 ms
Normal 2 ms 10 ms
Fast 500 µs 2 ms
Very fast 250 µs 2 µs

Table of Contents

Related product manuals