5-66
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Run Menu
Section 5
Fragile WBC and Resistant RBC
If the specimen type selected is FRAGILE WBC, then the label “FrgWBC” appears
instead of “Name” in the Demographics Section. If the specimen type selected is
RESISTANT RBC, then the label “ResRBC” appears instead of “Name” in the
Demographics Section.
QC Specimen, Background, Latex
If the specimen type selected is 4&63(&,0(1, %$&.*5281' or /$7(; the
following information is displayed in the Demographics Section:
Type—displays the name of the QC file or displays Background or Latex. For a QC
file, the number of runs in the QC file and total file space is displayed to the right
of the type as in the following example:
XX/120-current number of specimens in a batch of 120 (applies only to QC
Specimens).
Param Set:—indicates the Parameter Set applied to the results run in the QC file.
For BACKGROUND and LATEX, the default Param Set is 1.
Status Box
The Status Box is displayed in the Top Center of the RUN screen. It contains the
following information:
•Menu in use
• The Status of the Analyzer — the READY, NOT READY and FAULT
messages are displayed here
• Report or File identity for results currently displayed
The Status Box also displays status and instructive messages during the run cycle.
These messages are:
Aspirating
Remove specimen
Dispensing
Counting
Rinsing
Ready
Upper Right Corner
The Upper Right Corner of the RUN screen displays the following information:
• Current date and time
• Operator ID — Identification of the current operator
• Sequence # — Automatically increments as cycles are run
• Selected Sampler mode — Open Sampler or Closed Sampler
To Next Page
Loading...
