5-104
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Using The Work List
Section 5
Quick Guide
The Work List has been designed with three objectives in mind:
1. Relieve the operator from the task of entering demographic data by
downloading that data from a host.
2. Process samples quickly, efficiently, and accurately.
3. Upload sample results with corresponding demographic data to the LIS for
distribution to authorized personnel.
SL Model
If the instrument is the SL model and bar codes are used with Work List entries, the
operator should do the following:
1. Wait for Work List entries to be downloaded from the host.
2. Place the samples in the racks and load the racks onto the Sample Loader.
3. In the RUN screen, press [CHANGE SAMPLER] to select the Closed Mode if
necessary.
4. Press [SPECIMEN TYPE] followed by the appropriate specimen type (Patient,
Fragile WBC, or Resistant RBC).
5. Press[START LOADER] to begin processing.
6. When processing is finished, verify that all entries have been deleted from the
Work List, indicating that all samples were successfully matched to their
corresponding entries.
CS Model
If the instrument is the CS model and bar codes are used with Work List entries, the
operator should do the following:
1. Wait for Work List entries to be downloaded from the host.
2. Place a sample tube in the Door Assembly and close the door.
3. In the RUN screen, press [CHANGE SAMPLER] to select the Closed Mode if
necessary.
4. Press[SPECIMEN TYPE] followed by the appropriate specimen type (Patient,
Fragile WBC, or Resistant RBC).
5. Press the Touch Plate to begin processing.
6. When processing is finished, verify that all entries have been deleted from the
Work List, indicating that all samples were successfully matched to their
corresponding entries.
To Next Page
Loading...
