8.1 Using the Web User Interface 38
8.1.1 Main View 39
8.1.1.1 Status Indicator 39
8.1.1.2 Current Time, Position and Heading 40
8.1.1.3 Altitude Indicator 40
8.1.1.4 Satellites Table 40
8.1.1.5 Map 40
8.1.1.6 Map Controls 40
8.1.2 View Menu 40
8.1.2.1 Map 40
8.1.2.2 Device Information 40
8.1.2.3 Status 41
8.1.2.4 Satellites 41
8.1.2.5 Raw Sensors 42
8.1.2.6 Orientation 43
8.1.2.7 Position 44
8.1.2.8 Velocity and Acceleration 45
8.1.2.9 GNSS Receiver Information 46
8.1.3 Configuration Menu 47
8.1.3.1 Sensor Ranges 47
8.1.3.2 Filter Options 47
8.1.3.3 Data Ports 47
8.1.3.4 Alignment 48
8.1.3.5 Reset 48
8.1.3.6 Manual Initialisation 49
8.1.3.7 Ethernet Settings 49
8.1.3.8 NTRIP Client 50
8.1.4 Tools Menu 51
8.1.4.1 Firmware Update 51
8.2 Using GNSS Compass Manager 52
8.2.1 Software Changelog 53
8.2.2 System Requirements 53
8.2.3 Installation and Starting 54
8.2.4 Troubleshooting 54
8.2.4.1 Windows 54
8.2.4.2 Linux 56
8.2.5 Main View 57
8.2.5.1 Serial Port 57
8.2.5.2 Baud Rate 57
8.2.5.3 Connect / Disconnect 57
8.2.5.4 3D Map 58
8.2.6 View Menu 58
8.2.6.1 Communications 58
Page iii