This refers to the efficiency of intake air volume.
Cyl1MAP_idx (INDICATION VALUE OF MANIFOLD PRESSURE)
This refers to the default value set up in the ECU. The default values will be used in case of pressure sensor mal-function.
Cyl1AFLCFilteredMAP (MANIFOLD PRESSURE READINGS)
This refers to the actual measuring values from the pressure sensor.
ColdCyl1VEFactorIdle (IDLE MODE VOLUMETRIC EFFICIENCY COEFFICIENT)
This refers to the BPW correction value according to different temperature in idle condition.
ColdCyl1VEFactorRun (RUN MODE VOLUMETRIC EFFICIENCY COEFFICIENT)
This refers to the BPW correction value according to different temperature in operation.
TPSLean (INITIAL LEANING VALUE OF THROTTLE POSITION)
This refers to the learning value at zero (closed) throttle position
TPS_AD (ANALOG TO DIGITAL OF THROTTLE POSITION SENSOR)
This refers to the digitized value according changes of throttle position. The value will be 255 if the sensor or its circuitry is
short to power, and will be 0 when open or short to ground.
AFRChokeIdle (IDLE MODE AFR CHOKE)
This is a simulation to the idle choke function similar to carburetor system.
AFRChokeRun (RUN MODE AFR CHOKE)
This is a simulation to the operation choke function similar to carburetor system.
AFRChokeDecayCounter (AFR CHOKE COUNTER)
This refers to the time after the engine start. It’s a calibration value according to different engine temperature.
PreBLM (PRE-BLOCK LEAN MEMORY)
It refers to the automotive correction with the learning function at vehicle off-line if the engine variance over certain level.
SAIdleDyn (IDLE SPARK ANGLE CORRECTION)
The correction is made according to the difference to target rpm in idle condition.
AFCorrectionState.EnableCondMet (AIR FLOW CORRECTION MODE)
This refers to the indication of opening of the mode.
IAT_AD (ANALOG TO DIGITAL OF IAT SENSOR)
This refers to the digitized value according changes of intake air temperature. The value will be 0 the sensor or its circuitry is
short to ground, and will be 255 if open or short to power.
Toil_AD (ANALOG TO DIGITAL OF CLT SENSOR)
To Next Page
Loading...
General