Since the headlight bulb gets extremely hot, keep
flammable products and your hands away from the
bulb until it has cooled down.
2.Inspect bulb for continuity with the multi-meter, If discontinuity
Replace the bulb.
NOTE: Before checking for continuity, set the multi-meter
to “0” and to the “Ω∗1” range.
3.Connect the tester positive probe to terminal
and the tester
negative probe to terminal
, and check the continuity.
4.Connect the tester positive probe to terminal
and the tester
negative probe to terminal
, and check the continuity.
5.If either of the readings indicates no continuity, replace the bulb.
BULB SOCKETS INSPECTION
1. Install a good bulb into the bulb socket.
2. Connect the multi-meter probes to the respective leads of the bulb
socket.
3. Check the bulb socket for continuity. If any of the readings indicate
no continuity, replace the bulb socket.
To Next Page
Loading...