• Never disassemble brake components unless
absolutely necessary.
• If any connection on the hydraulic brake system is
disconnected, the entire brake system must be
disassembled, drained, cleaned, properly filled, and
bled after reassembly.
• Never use solvents on internal brake components.
• Use only clean or new brake fluid for cleaning
brake components.
• Brake fluid may damage painted surfaces and
plastic parts. Therefore, always clean up any spilt
brake fluid immediately.
• Avoid brake fluid coming into contact with
as it can cause serious injury.
• FIRST AID FOR BRAKE FLUID GETTING
INTO THE EYES:
• Flush with water for 15 minutes and get immediate
medical attention.
1. Visual inspects the junction and line locked fluid leaking
2. Turn handle bar full right and full left to inspect brake hose
whether contact movement parts.
3. Press the front fork by handlebar to inspect brake hose
whether interferes other parts.
4. Remove front brake calipers. Do not apply the brake lever
when removing the brake calipers.
5. Inspect brake pads wear limit
6. Keep fluid level in the master cylinder reservoir to the
indicated level inside reservoir.
Use DOT 3 or DOT4 Brake Fluid.
BRAKE BLEEDING / FLUID CHANGE
NOTE: When bleeding the brakes or replacing the
fluid always start with the furthest caliper from the
master cylinder.
Always wear safety glasses.
To Next Page
Loading...
General