• Make sure that only approved tyre types are in use on the machine:
- Tyres not approved by the manufacturer can be dangerous
- Examine the transport wheel nuts and tighten them if necessary after the set working hours or
driven distance
- Make sure that the tyres have the correct pressure. Do not inflate the tyres with more than the
recommended quantity of air.
• Do not operate hydraulic components
• Know the height of the machine. Always keep a minimum distance of 3 m (10 ft) between the machine
and electrical power lines, specially when you open the tailgate.
1.2.5 Safe Maintenance
Read and understand the general safety instructions then:
• Before you do maintenance or do work on the machine:
- Make sure machine is parked on level ground
- Stop the tractor engine and remove the key
- Disengage the Power Take-O (PTO)
- Stop all the parts that can move
- Put the wheel chocks against the wheels.
• Do not touch parts in movement
• Obey the maintenance schedule in the manual to prevent problems
• Do not change the machine
• If it is necessary to replace parts, only use parts with manufacturer approval
• Make sure that all covers and guards are in position and locked when you complete maintenance work.
1.2.6 Safe Operation
Read and understand the general safety instructions then:
• Before you start to work with the machine do a visual inspection
• Make sure that no changes occurred to the machine and no components are missing
• Make sure that there are no unusual noises or leaks during operation
• Only use the manufacturers instructions when you operate the machine
• Do not get on or into the machine when it is operating
• Make sure that you disengage the Power Take-O (PTO) shaft, stop the tractor engine and remove the
key before you remove crop material from the machine
• Make sure that you disengage the PTO shaft, stop the tractor engine and remove the key before you
put in the net
• Correctly attach the net knife safeguard before you do work on or near the net knife
• Protective gloves must be in use when you do work on the net knife or on the knives of the cutting
device
• Do not go near the tailgate area while in operation
• Make sure that the PTO shaft is o, the tractor engine stopped and the ignition key removed, before
you install the plastic film rolls
• Control the machine from the operators seat only. Do not transport other persons on the machine
• When the machine is in operation do not climb on the drawbar or other parts of the machine
• Do not put metal parts near to the machine. This causes accidental operation of the proximity sensors
and unwanted movements of the machine
• Stay out of the machines danger zones while in operation.
• Do not sit or stand on or in the machine or wrapper
• On a slope always put bales in a position in which they cannot move down the slope
• Make sure that there are no people or animals in the danger zone during operation. This is important in
or near areas that are open to bystanders
GUID-2C4DE7D7-47C2-4807-91A6-6F5AB7D368AB [V1]
GUID-56B2ECA5-959E-4B96-8C8E-7F7810A94A82 [V1]
1. Safety
12 Baler Wrapper Combination
4900.LE.EN01
To Next Page
Loading...
Need help?
General
