Procedure
1. Open the top cover (1).
2. Pull the handle (2) of the net knife carrier to
the front if necessary.
3. Attach the safety chain (3) and attach it with
the clip (4).
GUID-2939BE9E-C1B4-4136-9D04-F64AA3A29C53-high.jpg [High]
Fig. 5
4. If you use a net length of 2000 m (6562 ft)
do the subsequent steps on the two sides:
1. Remove the rods (1) from the bottom
position.
2. Put the rods in the top position holes (3
and 4).
5. If you use a net roll with a width of more
than 1.23 m (4.0 ft) remove the extension
spindle (2), for a net roll smaller than 1.23 m
(4.0 ft), make sure that the extension spindle
is in position.
GUID-C20C8312-2BA8-49BD-9B30-7A8469525F2A-high.jpg [High]
Fig. 6
6. If the net roll is not in the centre with the
extension spindle in position, you must
adjust the position of the net roll on the two
sides:
1. Loosen the bolts (3) in the slotted holes of
the position holder (1) and move the position
holder until the net roll is in the centre of the
bale chamber.
2. Tighten the bolts.
7. Remove the safety chain (2) from the handle
(1) of the net knife.
GUID-40F2ED18-33DE-401A-B1C8-D53252787ABF-high.jpg [High]
Fig. 7
8. Close the top cover (4).
3.1.10 Adjust the Pre-stretch Rate
Before starting the procedure
For bale wrapping with film, the film must be pre-stretched to a set length.
GUID-F8BE9175-6A6F-4AC5-B419-153AD38F913F [V1]
3. Operation
Baler Wrapper Combination 73
4900.LE.EN01
To Next Page
Loading...
Need help?
General
