2.1 Preface
2.1.1 Manual Contents
This manual contains the technical information, operating instructions, maintenance procedures and the
troubleshooting information necessary to operate the machine.
The information in this manual is for the operator.
Make sure that you fully understand all the information before you operate the machine. If you do not,
personal injury or damage to the equipment can occur.
Speak to your local approved dealer if you do not understand the information in this manual, or if more
information is necessary.
All the information in this manual has been collected carefully. The manufacturer cannot guarantee that the
manual is free of errors in all languages and will not be liable for errors or faults in this manual.
All areas of information in this manual are recommendations on the economical use and safe operation of
this machine.
All the instructions, illustrations and specifications were correct when this manual was written.
Your machine can have equipment and optional components not shown in this manual.
Standard Torque Loading of Parts
Tighten all the nuts, bolts and screws used on the machine to the standard torque applicable to the
materials used in assembly.
If a component does not have a standard torque value, the correct value is specified in the applicable
section of the manual.
2.1.2 Vehicle Identification Number (VIN) and VIN Plate
The Vehicle Identification Number and VIN plate of the machine are on the right side of the chassis frame.
Always include the VIN number of your machine when you speak to your local service provider or when
you order replacement parts.
[V]
GUID-DA7EE6BA-4E1C-4352-A16F-10C3C1DA7D43 [V1]
GUID-2176DADC-C088-44AF-82A5-8362E77759AC [V1]
2. Introduction
Baler Wrapper Combination 35
4900.LE.EN01
To Next Page
Loading...
Need help?
General
