Agilent Technologies 1260 - Page 222

222 Agilent 1260 Infinity DAD and MWD User Manual
10 Maintenance
Nano Flow Cell - Replacing or Cleaning
Figure 76 Wrench plus Torque Adapter
NOTE
The cell body can be fitted in two positions to allow the capillaries routed upwards or
downwards (depending on where the column is located). Route the capillaries directly
column (inlet) and waste assembly (outlet).
NOTE
With the instrument accessory kit comes a 4-mm wrench and with the Sealing Kit a special
adapter. Both together work as a torque wrench with pre-defined torque (maximum allowed
torque for the cell fittings is 0.7 Nm). It can be used to tight the capillary fittings at the flow
cell body. The wrench has to be plugged into the adapter as shown in Figure 76 on
page 222.
LgZcX]
6YVeiZg
9DCDIegZhhYdlc
bdgZi]Vch]dlc]ZgZ
bVm
%#,Cb