> > > > 4 Move across to the COMMA command on the commands level.
> > > > There are eleven command choices available in the SYS MENU. Each choice
on this level has a number prefix for easy identification (
1: , 2: , etc.).
9: COMMA
∨ 5 Move down a level to the COMMA parameter choices.
The first parameter choice is ON for the COMMA command (the comma
setting is stored in non-volatile memory and ON is the factory setting).
ON
> 6 Move across to the OFF choice.
There are two parameter choices for COMMA.
OFF
Auto/Man
ENTER 7 Save the change and turn off the menu.
The meter beeps and displays a message to show that the change is now in
effect. You are then exited from the menu. The meter will no longer show
commas in the display.
ENTERED
Chapter 2 Front-Panel Operation
A Front-Panel Menu Tutorial
36
To Next Page
Loading...
