Agilent Technologies 6500 Series User Manual

Agilent 6500 Series Q-TOF LC/MS Maintenance Guide 3
Content
1 Basic Operation 7
Starting and Shutting Down 13
To start the system in Standby mode 15
To change from Standby to On 18
To change from On to Standby 18
To shut down the instrument 19
Changing Ion Sources 21
To remove an electrospray source 21
To remove the ESI with Agilent Jet Stream Technology 22
To remove a multimode source 22
To remove an APCI or APPI source 23
To remove a nano ESI source 24
To remove a dual nano ESI source 25
To install an electrospray source 26
To install an APCI source 27
To install an APPI source 28
To install a nano ESI, dual nano ESI or multimode source or HPLC-Chip/MS
interface 28
To install the Agilent Jet Stream inlet assembly 29
2 Maintenance 31
Calibrant Delivery System and Divert Valve 32
To prepare tuning mix 35
To prepare the reference mass solution 40
To check calibrant levels 43
To fill a tuning mix or reference mix bottle 44
To check for l e a k s 45
To replace the LC filter elements 46
To replace the MS selection valve rotor seal 47

Agilent Technologies 6500 Series Specifications

General

Brand	Agilent Technologies
Model	6500 Series
Category	Laboratory Equipment
Language	English