The Stability Application Applications
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave
Multichannel System, Fourth Edition
179
19 When the stability application completes, you hear a beep, an hourglass
appears momentarily. If you are viewing the Stability Measurement Screen,
the available softkeys change as shown in Figure 130.
Analysing a Stability Application
You can access the Stability Analysis screen after the stability application
completes, by completing the following instructions:
20 You cannot access the Stability Analysis screen from the graph. If you are
viewing the graph, press [Close].
Figure 131 The Stability Measurement Screen - Measurement Completed
To Next Page
Loading...
Need help?
General
