Using the System Utilities Additional Information
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave
Multichannel System, Fourth Edition
63
3 Move to your chosen triggering mode and press Enter.
How to Configure your Foot Pedal
You can use a Agilent 81610FP Foot Pedal (Part Number 81610-68709) to
generate triggers. This accessory is similar to a mouse, you press the Foot Pedal
and a trigger is generated. You can attach the Foot Pedal to the Input Trigger
BNC Connector, see “Input and Output Connectors” on page 216.
To configure your Foot Pedal:
1 Press the Config hardkey.
2 Move to the <Foot pedal support> menu option and press Enter. You see a box
displaying <On> and <Off>.
3 Move to <On> to enable the Agilent 81610FP Foot Pedal or move to <Off> to
disable the Agilent 81610FP Foot Pedal.
4 Press Enter.
How to Get Information About Modules
To get information about modules:
1 Press the Config hardkey.
Figure 37 Enabling/Disabling the Foot Pedal
To Next Page
Loading...
