The PACT Application Applications
Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement System, & Agilent 8166A Lightwave
Multichannel System, Fourth Edition
183
How to Set Up PACT
To set up PACT:
1 Insert a Tunable Laser module and at least one Power Meter module into your
Agilent 8163A Lightwave Multimeter or Agilent 8164A Lightwave
Measurement System.
2 Turn your instrument on.
3 Press the Appl hardkey. The Applications menu, as shown in Figure 117,
appears.
4 Move to <PA C T > and press Enter. The PACT Setup Screen, as shown in
Figure 135, appears.
Selecting a Tunable Laser Module
5 Move to the Module Selection box. As a default, the Tunable Laser module
with the lowest slot number is selected. Move to [Laser Selection]. Press
[Edit].
6 To select a Tunable Laser module, press [Edit], use the cursor key to move to
your preferred Tunable Laser module as denoted by slot and channel numbers,
see “Slot and Channel Numbers” on page 36, and press Enter.
7 Perform steps until you have selected the required Tunable Laser modules for
your application and press Enter.
NOTE If no Tunable Laser module is selected, you cannot exit by pressing Enter.
Figure 135 The PACT Setup Screen
To Next Page
Loading...
